Gen 3 Router Mount - Installation Guide. Below are steps listed to connect a Gen 3 router in combination with a Gen 2 Router in use:. Starlink Standard Kit - Setup Guide. What is Bypass mode? How do I set up Starlink Mesh? I cannot get online during initial setup. Can't find what you're looking for? Contact Support. Help Center Home Articles. Help Center Home.
Service Plans.
What You Need for Starlink Installation
App Install Tools. How do I set up Starlink? Where is the Starlink Standard Kit available? Where is Starlink Please click for source available? Where is Starlink Enterprise Kit available?
Why do I need to align my Starlink?
Install Starlink: A Comprehensive Guide to Getting Connected
How to install Starlink on starlink. General Install Guidance. Starlink Kits. Hookup 1 Router - Setup Guide. Gen 3 Router - Setup Guide.
Gen 2 Router - Starlink Guide. Who can purchase the Starlink Gen 3 router? Gen 3 router specifications: Starlink If the router cannot get a connection to the internet in 20 minutes, the light will turn red.
Solid White Light: Connected to internet. Will turn off after 1 hour. No Light: No power to router. Red Light: Not connected to the internet.
Step-by-Step Starlink Installation Guide
Violet Light: Router is in bypass mode. Factory reset required to exit bypass mode. This step is optional, however we recommend securing your WiFi network. Your Starlink WiFi network is not password protected until you set the password.
You are now connected! To customize additional settings, check your connection, and more, visit the Starlink App. Below are steps listed to connect a Gen 3 router in combination with a Gen 2 Router in use: Ensure your Starlink is set up and connected to the internet prior to setting up the Gen 3 router by connecting to your existing Starlink WiFi network from your device.
We recommended placing both routers in the same room for the best performance, or to choose a location for your Gen 3 router that is in line of sight of your Gen 2 Router. After unboxing your Gen 3 router, plug the router into a power outlet with the power cable and power supply. The light should hookup solid white. Plug in your own ethernet cable to port 1 or 2.
Then connect the other end of your cable into your third-party hookup. Additional Notes: A standard RJ45 cable can be used in lieu of the Starlink RJ45 cable; however, it is recommended that the provided Starlink RJ45 cable is used to ensure proper sealing. The latching mechanism inside the Starlink RJ45 hookup is completely passive starlink only requires a firm tug to remove the cable. It should be possible to remove both the Starlink RJ45 cable or a standard RJ45 cable just by pulling it.
If you install a standard RJ45 cable in the Starlink RJ45 port hookup cannot pull it out, you can use a small screwdriver or similar tool to depress the tab which should release the cable. Search support articles.
For specific guidance related to setting up your Starlink Kit or how to use any starlink, click here.